Posts: 618
Threads: 32
Joined: Feb 2009
Well yet another latch went out this week that's 10 bad 2 to go. Plus 2-3 were newer ZooMeds so they have Not fixed the issue.
At least I am prepared, keep a Swiss Army knife in my frogroom to take care of broken latch's so I can get the door open.
Yes I have tried the replacement latches they break as well.
Any ideas on something I can use for a latch other than a piece of blue painters tape to keep the door(s) closed?
-Beth
Posts: 1,486
Threads: 94
Joined: Feb 2012
Can you post a pic showing how they break? I only have two zoomeds and an exo with no issues yet. Curious to see what the problem looks like. Maybe seeing a picture will spark a few ideas.
Posts: 10,391
Threads: 871
Joined: Oct 2008
I actually LIKE it when they break. I use a small sharp craft saw and saw the plastic that sticks up, completely off -making it flat.
Then, the hole/loop for the optional lock is still there and I use a small dowel with a electrical taped top, as a little stake, to put thru the hole and it all seals nicely.
Even though they break 'less', I'm not a fan of Exoterra's plastic clasp/lock mechanism either.
Posts: 758
Threads: 8
Joined: Aug 2009
A golf tee? Not sure if it would be wide enough.
Glenn
Posts: 1,486
Threads: 94
Joined: Feb 2012
Wondering if you could retrofit with a magnetic catch. Silicone the magnet on the right side glass and the plate on the front door? May be worth and experiment since they are only a few bucks. Any concerns with a magnet in the viv?
Posts: 535
Threads: 54
Joined: Jul 2011
I use the same type of thing that Phil does. I've actually intentionally broke some of them because I prefer just pulling out a pin as opposed to using a latch at all. Sometimes the latches make so much noise that it scares any froglets or the adults.
Posts: 10,391
Threads: 871
Joined: Oct 2008
Craig...snap and post a pic.
Also....you can get all types of wooden dowel rods and stakes ect, at Michaels, hobby Lobby or any given big craft store. The key is to make sure the rod diameter is a close fit - not much wiggle room, so the doors shut and stay closed nicely.
Posts: 758
Threads: 8
Joined: Aug 2009
I did like the one's I saw at your place, Craig. It make sense not to have a latch.
Glenn
Posts: 114
Threads: 1
Joined: Mar 2012
Hello All
the reason they break is because the original spring that is inside the bottom piece is to strong and it causes the plastic shaft on the latch to break over time, they have redesigned them with thinner springs for replacements. If you call them and let them know what happened they will send you out a replacement latch, but be for warned they are a b@#%^ to replace if you have them set up for frogs. You need to be able to get to the screw on the back side of the latch which is on the inside of the tank. It is a;most worth the frustration to just remove the frogs and lay it on it's face and work from the open top, but like i said the fix is not conducive to a set up frog tank, more for dry land displays, i have replaced 8 0f these on my frog tanks. the easiest way is just a peg through the lock hole, what works best and is not has noticeable is " and you northerners will love this" a cribbage beg!!
Regards Jerry A